Change a Propane Tank
Forklifts powered by propane are common inside warehouse settings. These forklifts have a propane mount situated at the rear of the operator. These tanks have to be replaced every so often because they have limited lifespans. Forklift drivers should utilize care when handling propane tanks. Compressed gases are very hazardous, particularly because the gas is flammable. Utilize caution when replacing and removing propane tank to avoid injury.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn off the tank valve. The lift truck must be left on until the engine dies. This procedure burns the gas off in the transfer hose that connects the tank and the engine. Prior to taking the second steps, wear the proper safety equipment, such as insulated gloves made of either leather or neoprene. It is really important for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The tank hose needs to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reattach the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 Leaks could be checked just by applying soapy water to the valve and slightly opening it. If there is a leak, it would cause bubbles to froth from around the valve. If this happens, inspect the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the valve area, and after that perform the leak checking procedure again. Persistent leaks mean that both the connecting hose and nut must be replaced. However, if replacing the nut and hose still does not stop the leak, the tank would need to be replaced.
4 Open the valve all the way to enable the gas to fill the connecting hose. Then you could start the lift truck and continue working.