In nearly all cases, most individuals spend quite a lot of money buying their lift truck. Therefore, it is really important to take good care of it in order to protect your investment well into the long run. It is a good idea to know the procedures which are undertaken during maintaining and taking care of this machine.
By starting up the forklift and listening carefully how it works is among the best ways to tell how good the engine is working. Like for example, if there are any misses or knocks, the machinery is faulty and this must raise several concerns. Additionally listen closely for any squealing noise which come from the belts since these noises would provide you with a wealth of information.
Some of the main parts requiring attention during maintenance consist of the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty parts must be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals must be cleaned when the above parts have been checked carefully. If the terminals are not clean, be sure to clean them properly. Each and every cell of the battery should be inspected in order to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and then change the filters. The fuel filters, hydraulic filter and the transmission filter have to be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
When the oil change has been completed and new filters have been fitted, visually inspect the drive axle from underneath the machine. Be sure to grease the axle if there is any grease fitting. Check the engine belts for any frays or cracks. If you find any, fix the problem accordingly. After that, check every other part of the machine like the wheels. If any type of fault or concern is detected, be certain to deal with it immediately so as to make sure the machine is working at its safest and optimum levels.